|
Rubber tube outer layer causes and treatment methods for the loss
General use in the water, oil and other industrial uses the rubber tube, but due to various reasons. Some customers reaction rubber tube outer layer appeared different degree of loss, below small make up for everybody detailed introduction of rubber pipe outer layer causes and treatment methods for the loss.
Rubber tube cracks appearance: in a cold environment, rubber tube appearance will crack subjected to bending the hose. If it is found that the rubber tube is the appearance of a crack, to observe the rubber tube gum whether cracks exist, and decide whether to immediately replace rubber tube. Therefore, in a cold environment don't move a rubber tube or overhaul of hydraulic system, when necessary, indoors. If the need for long-term work in a cold environment, should replace the cold resistant rubber tube.
Rubber tube unruptured but a lot of oil leakage: if the hose is not found to rupture but a lot of oil leakage, its reason is in the hose by high pressure liquid flow, the inner rubber by erosion, abrasion, until a large area leakage wire layer leads to a large number of oil leakage.
Rubber tube surface bubble: rubber tube surface bubble is because the rubber tube quality unqualified or improper use. If the bubble appears in the rubber tube middle section, for the production of many quality problems of rubber tube, rubber tube should be replaced in a timely manner if qualified; bubble appears in the joint rubber tube, is likely to be due to improper joint installation. Woven wire, winding a rubber pipe connecting end connector and the hose are detachable, withholding type two kind of forms, there are six angle contoured detachable joint coat and the joint core, the outer wall of the joint core is a conical shape, convenient disassembly and hose. The core and the nut joint connection, inserting the steel to prevent loosening. Pressing type rubber pipe joint by joint coat and the joint core assembly need to peel the outer rubber layer, set of people connected core head, tighten the joint coat, and then use the mould withheld on special equipment, so that the rubber tube get compression certain, closely attached to the.
TAG: rubber tube
This article from the Shenzhen City Qiyu Silicone Rubber Co., Ltd.: http://www.szhcty.com/news_v.asp? Id=234
In this paper, or feel like this to help you, please share it with your friends ^_^
|
Online Service 